Jim, KD4OM – I am using a Kenwood TS 850 here and have for several years. Схемотехника современных радиотелефонов базируется на последних достижениях радиоэлектроники, а постоянное совершенствование электронных компонентов определяет повышенную степень сложности этих устройств. Can also do FSK via the same port.
There it slipped right into the console space where I had kept the backup 870 and the 570 that preceded it. The radio also has a rear-panel input for AFSK. Dale, W6IWO – I use a Ten Tec Omni V radio here. It was setup at the factory with special optional 6.3 Mhz IF filters. It has PBT and a 500 Hz is recommended for digital modes. First, this radio comes with a USB interface that simplifies computer integration. Additions in PAGING partition — new version of control software for POC32 posag decoder. Can be coupled with any of Roland’s MIDI pedal keyboards to make it a complete organ. 2012 Roland Jupiter-50 Synthesizer: A reduced JP-80 with three parts instead of four and a smaller non-touch screen.
Just after I got it running I was working EU stations and had people come in above and below me, I don’t think the 756 or the 940 could have stood it, but the DSP on the Flex was dialed down to about 200 hz and the QSO’s went on. Then in the fall of 2002, I stumbled onto a VHF portable contesting setup on a mountain top here in southern Maine. Second receiver good for S&P on same band as run (single radio operation). Four pin DIN connector required to wire for FSK. Army, AE5P – The ‘756 is very well suited to RTTY operation. I have used mine exclusively on FSK, although AFSK is also possible. Jay, WS7I – Have tried both the 500Hz and the 350Hz filters. 350Hz are better, a nice little performer. A little better than a ‘751A and a lot smaller.